Tidy Nest
← Back to home
Cleaning

How to Clean a Washing Machine (and Why It Smells)

Tidy Nest Editorial · 2026-11-20 · 3 min read

If your clean laundry smells faintly sour the moment you take it out, the machine is the problem, not the detergent. Washing machines accumulate a film of detergent residue, fabric softener, lint and body oils in places you never see: the door seal, the detergent drawer, the drain filter and the outer drum.

That film is food for bacteria and mould. The smell is the by-product. Cleaning the drum is only part of the job — the seal and filter matter more, and they are the parts most people skip.

Where the smell actually comes from

The door seal on a front loader. The rubber gasket folds back on itself and traps water, lint and hair. Run a finger around the inside of the fold and you will find a grey sludge. That is the source of most musty smells.

The detergent drawer. Liquid detergent and softener leave a residue that never fully rinses. Over a year it becomes a dark, gummy layer.

The drain filter. Coins, hair and grit collect here. A blocked filter also slows drainage, which leaves standing water in the drum.

Too much detergent, and too low a temperature. Constant 20°C washes with generous doses of liquid detergent keep the film soft and never flush it out. This is the single biggest cause of the problem in modern efficient machines.

The monthly habit that prevents it

Two minutes, once a month:

  1. Wipe around the inside of the door seal with a damp cloth.
  2. Pull out the detergent drawer, rinse it under the tap, and wipe the housing behind it.
  3. Run the hottest programme with no laundry and no detergent.

That last run — a hot empty cycle — is what most people never do. It dissolves residue that cold washes leave behind. If your machine has a drum-clean or tub-clean programme, use it.

The deep clean, once or twice a year

Start with the filter: place a towel down, unscrew the access panel at the bottom front, and let the water drain into a shallow tray. Clear the debris and reseat the cap firmly.

Then clean the seal properly. A dilute solution of bicarbonate of soda and water, worked into the fold with an old toothbrush and wiped out with a cloth, removes the film without damaging the rubber. Do not use bleach on the seal — it hardens the rubber and causes cracks, which then leak.

For the drum, run a hot cycle with either a proprietary washing machine cleaner or 500 g of bicarbonate of soda followed by a hot rinse. White vinegar works too, but keep it away from the rubber seal and never mix it with chlorine bleach. If you are unsure about combinations, our guide to why you should never mix cleaning products covers the dangerous ones.

Finish by leaving the door and the detergent drawer open until everything is dry. Mould needs moisture, and a closed door is a humid box.

Habits that stop it coming back

When to call someone

A persistent smell after cleaning, dark mould that keeps returning on the seal, or water pooling under the machine all point to drainage or seal problems that cleaning cannot fix. A replacement seal is an inexpensive part and usually solves the mould issue permanently.

For the laundry itself, the same principles apply: less detergent, hotter washes occasionally, and a clean machine. Our post on the most common laundry mistakes covers the loading and sorting side. A machine that smells neutral is most of the way to laundry that smells clean.

Tip: always follow product labels and care instructions, and test cleaners on a hidden spot first.

Keep reading