How to Stop Condensation on Windows
Condensation on windows is the most reliable sign that a home is holding too much moisture. In winter the glass is the coldest surface in the room, so water vapour in the air condenses there first. Wiping the windows every morning treats the symptom; the water keeps coming back because the cause is unchanged.
Left alone, that moisture does more than look bad. Water sitting in window frames feeds mould, damages paint and softens plaster. In badly ventilated homes it is the main reason black mould appears in corners and behind furniture.
Why it happens more in winter
Warm air holds more water vapour than cold air. A heated room at 20°C with normal cooking and showering can hold twice the moisture of the same air at 8°C. The moment that air touches cold glass, it cannot hold the vapour any more and drops it out as liquid.
That is why the problem appears in the first cold weeks and disappears in summer — the moisture load is the same all year, but the surfaces are not.
Fix ventilation first, then humidity
Ventilate deliberately. Ten minutes of wide-open windows twice a day exchanges air faster and loses less heat than leaving trickle vents open all day. Do it after showering and cooking, when the moisture load peaks.
Use extractor fans every time. Bathroom and kitchen fans need to run for 10 to 15 minutes after you finish, not just during. If the fan is weak or noisy, that is the single best upgrade in the house.
Keep the kitchen lid on. A pot of pasta releases a surprising amount of steam. Lids and a running extractor cut it dramatically.
Dry laundry outside, or in a room with the door shut and a window open. Indoor drying on radiators is one of the largest single sources of household moisture.
Do not block radiators under windows. The warm air rising across the glass is what keeps the surface above the dew point. Long curtains tucked behind a radiator do the opposite.
The small habits that help
- Leave a gap between furniture and exterior walls so air can circulate.
- Open the bathroom window after showers, even in cold weather — five minutes is enough.
- Wipe frames dry rather than letting water pool in the channel.
- Check the drainage slots on uPVC frames are clear; blocked slots trap water inside the frame.
What does not work
Wiping every morning. It removes water but not vapour. Useful for preventing damage, useless as a solution.
Dehumidifiers as a permanent fix. They work, and in a flat with no extractor fan they may be the only practical option, but running one constantly uses real electricity. Our guide to cutting home energy use covers where the balance usually sits.
Anti-condensation paint and films. They spread the water into a thinner film so it is less visible. The moisture is still in the house.
Closing all vents to keep warm. This is the classic cause of a mould problem. A sealed, warm, damp home is the worst combination available.
When it is a building problem
If one window condensates heavily while others in the same room stay clear, or water appears between double-glazed panes, the issue is the unit itself — a failed seal lets moisture into the cavity and no amount of ventilation will fix it. That needs a glazing repair.
If condensation is on walls rather than glass, and worse behind furniture, suspect a leak or rising damp rather than humidity. Get that checked before spending money on dehumidifiers.
For the air side, changing filters on schedule keeps airflow where it should be — see our notes on air filter replacement. And if mould has already appeared around frames, deal with it properly: our guide to bathroom mould prevention covers the cleaning and the prevention in one place.
The short version: less moisture in, more air through. Everything else is a delay.
Keep reading
Seven Easy Ways to Cut Home Energy Use
LED bulbs, idle-power hunting, draft sealing and thermostat habits — the changes that cut energy bills, ranked by effort and payoff.
Home CareHouseplants for Beginners: Care Basics
Light, water and drainage — the three things that decide whether a houseplant thrives. Plus the forgiving starter plants and the pet-safety check.
Home CareBathroom Mold: Why It Grows and How to Stop It for Good
Mold needs moisture, warmth and stillness — the bathroom has all three. Ventilation habits, the cleaning methods that work, and when mold is a bigger